Wooden world maps

Map installation
To install the map on the wall is not difficult. You will receive detailed instructions for installing a single-level or multi-level wooden map together with the order. Please read carefully the installation instructions for the map.
Installation of a single-level world map
A single-level wooden map is mounted on the wall using transparent sealant or liquid nails.
  • 1
    Read the instructions for installing the map. To determine the actual size of the map, we recommend you first to spread it out on a table or floor.
  • 2
    Measure your wall to outline the location of the continents and avoid re-glueing of the map parts.
  • 3
    It's easier to start installation from one of the edges. The lining on the back of the instructions will help you.
  • 4
    The map is mounted on the wall with a transparent silicone sealant or liquid nails. Apply glue to the backside of the map and press it to the wall for a few seconds. The parts are lightweight, so they will stick tightly to the wall.
  • 5
    Glue large countries so that their names should be parallel to the floor. The rest parts will come together as a puzzle.
  • 6
    If it's necessary, adjust the position of the parts on the wall until the glue hasn't dried. Glue the islands according to the scheme.
Installation of a multilevel world map
  • 1
    Read the instructions for installing the map. To determine the actual size of the map, we recommend you first to spread it out on a table or floor.
  • 2
    Measure your wall to outline the location of the continents and avoid re-glueing of the map parts. It's easier to start installation from one of the edges. The lining on the back of the instructions will help you.
  • 3
    In the box with the map you will find the remote holders, bolts and glue necessary for installation.
  • 4
    On the back of the map, find the black squares - these are the places for attaching the remote holders. Take the transparent part of the holder and glue it to the black square with a flat round side. Caution with glue - if it gets on clothing, glue can damage it. Wait for the glue to dry completely.
  • 5
    Lean the part with glued parts of the holders to the wall. They will leave marks where you need to drill a hole for mounting the second part of the holder.
  • 6
    Connect the bolt and the second part of the holder, insert into the prepared hole. Fix the holder to the wall.
  • 7
    Connect the map and wall holders. They should snap into connection place. Glue the islands according to the scheme.
Installation of a world map with backlight
The wired backlight card assumes that the card will turn on and glow from the power supply.
  • 1
    In order not to see the wires (0.75 shvvp), at the stage of repair it is necessary to hide the wires in the wall (channels) according to the attached diagram.
  • 2
    It is necessary to provide a niche for the power supply according to the attached diagram.
  • 3
    Attached places on the backside. You need to glue the small part of the remote holder with the flat side to the card.
  • 4
    Press the mainland and the holders against the wall according to the diagram so that the wires are behind the card, the sharp edges of the holders will leave marks on the wall
  • 5
    In these marks, you need to drill a hole and screw the second part of the holder.
  • 6
    The card comes with an LED strip power supply. Connect the plug from the power supply to 220 V (into the socket) Connect the wires from the card to the opposite part of the block.
  • 7
    Connect the wires to the card. Connect the card to the wall holders until they snap into place.